Header
Specials
box
The Runt 350,000 volt Stun Gun
The Runt 350,000 volt Stun Gun
 $45.70  $33.36 
box
LIVE HELP
box
SEE SOMETHING
YOU LIKE?
SHARE WITH IT
YOUR FRIENDS!
Share


box
Categories
box
Bullet Proof Vests (21)
Executive Bullet proof Vests (1)
Ladies Bullet proof Vest (3)
Stab Proof/Bullet proof Vest (6)
Civilian Bullet proof Vests (15)
Concealable Bullet proof Vests (5)
Military Helmets (15)
Level III Rifle Plates (3)
Shoulder & Arm Protection (1)
Groin Protection (1)
Stun Guns / Taser Guns (41)
box
Search Catalog  Search Catalog
box



Use keywords to find the product you are looking for.
Advanced Search
box
We Support our Troops
box
marines_sign_up

army_signup
box

IN ORDER TO INSURE A PROPER FIT ON YOUR ARMOR, PLEASE READ ALL INSTRUCTIONS COMPLETELY BEFORE BEGINNING

  • You MUST wear a complete uniform and gun belt.
  • DO NOT take any measurements unless you are wearing your duty belt.
  • Empty all shirt pockets and stand or sit comfortably while being measured.
  • Do not watch the person measuring you.
  • Stand or sit relaxed and look straight ahead. Do not slouch and do not "stand tall"

Correct measurements are the responsibility of the customer. If you have any questions please call BulletproofBodyArmorHQ.com (928)303-5979

USE THE SIZING CHART BELOW TO HELP DETERMINE THE PROPER SIZE NEEDED

 
These drawings illustrate the difference between the Contour model (Left) and the full coverage model (Right). The Contour model has a standard width back panel while the width of the Side Panel model back panel varies depending on the size ordered.
 
Chest Measure
completely around the chest at nipple height with arms at sides. make sure to keep the tape at an equal height around the chest.

 
Waist Measure
completely around waist just above belt height. Stand normally and
DO NOT SUCK IN YOUR STOMACH OR HOLD YOUR BREATH.
 
Front (standing)
Measure from the second shirt button (the collar button is the first button) down to the top, center front edge of the gun belt.
 
Front (sitting)
Repeat the same procedure as Front Standing while seated. Sit comfortably.
DO NOT SIT SLOUCHED OR RIGIDLY UPRIGHT.
 
Back
Place the top of the tape as shown. (Position should be 4 inches down from the collar seam.) measure to the top, center back edge of the gun belt.
 
Belt to Belt
Measure from the top edge of the gun belt (in the back) over the center of the shoulder ... ....
 
Belt to Belt
to the top edge of the gun belt in the front. Be sure tape is straight down the front and back. (Notice that the tape measure on the front lies on top of the shirt pocket.)

PLEASE NOTE:
Armor Panels require a 2" to 2 1/2" gap between the gun belt and the bottom of the vest when standing. This open area is necessary to prevent the vest from riding up while seated.

 Continue 
Shopping Cart  Shopping Cart
box
0 items
box
Security Seal
box

Official PayPal Seal

box
Prefered Payment
box
BOX_INFORMATION_CARD
BOX_INFORMATION_CARD
box
Login  Login
box
Your Email Address
Your Password

No account? Register here.
box
Sponsored Links
box
special_operations_warrior_foundation

herosbanner

optics_planet
box
Advertise Here  Advertise Here
box
Avertise Here
box